Adhol No.10 - 30kg

Adhol No.10 - 30kg

Adhol No. 10 is an additive used for blending with Caustic Soda solutions. It is specifically designed to boost the detergency of not readily saponified or hydrolysed soils by supplying a source of active oxygen.
Adhol No. 10 is designed primarily for use in breweries, beverage, dairy, and food processing plants, but it is also suitable for use in other high-care industries.

USE INSTRUCTIONS

• Adhol No. 10's in-use concentrations are application-dependent and should be established during trials. For occasional deep cleans, concentrations will typically be between one-third and one-half of the caustic v/v concentration. If Adhol No. 10 is used for routine cleaning, lower concentrations should be used, typically between one-tenth and one-quarter of the caustic v/v concentration. Maximum concentrations will typically be 0.5% v/v.
• Cleaning temperatures should be optimised during trials, but for maximum benefit must be between 70 – 80°C. Temperatures should not be allowed to exceed 85 – 90°C, at this level the evolution of oxygen will be very rapid and the detergency benefit will be lost.
• It is important to note that long-term poor concentration control through overdosing, poor temperature control, or local hot spots could result in discolouration of Stainless Steel.
• Adhol No. 10 is not designed for direct food contact.
• The following are typical example applications. Users should refer to Cleaning Instruction Cards for specific guidance. Other applications should be discussed with your Holchem Consultant.
• General Use. The addition of Adhol No. 10 to caustic causes the evolution of oxygen bubbles. These have a scouring and oxidising effect on soils.
• Although Adhol No. 10 can be added at any point in a CIP or boil-out clean, it is better to run for approximately one-third of the CIP cycle with caustic before adding Adhol No. 10. A second additive can then be introduced two-thirds of the way through the clean. Using this split dosing technique will reduce the potential for discolouration of Stainless Steel surfaces. Alternatively, the dose should be delivered slowly throughout the entire cleaning cycle.
• Because Adhol No. 10 evolves oxygen bubbles, it is essential to ensure that the circulation loop is vented or, if fitted, that pressure relief valves are operating.
• In some applications excess foam may be generated, in these circumstances Adhol No. 10 can be used in conjunction with Defoam.
  

BENEFITS

• Adjustable rate of addition to meet requirements.
• Cost-effective.
• Boosts performance of caustic solutions.

PRODUCT COMPATIBILITY

CAUTION: Contact with chlorinated products may release Toxic Chlorine Gas.
Adhol No. 10 is safe for use on 304 and 316 Stainless Steel when used at recommended temperatures and concentrations. However, it must not be used in combination with caustic on Aluminium, Copper, Zinc, and their alloys; this will result in the simultaneous production of Hydrogen and Oxygen Gases. Also, avoid contact with combustible material.

BIODEGRADABILITY

Adhol No. 10 breaks down completely to water and oxygen.

SAFE HANDLING & STORAGE

Keep in original container. Keep containers tightly closed. Store away from chlorinated and other oxidising or reducing materials.
COSHH requires employers to assess and control the risks of using hazardous substances. The Safety Data Sheet provides information about the product to assist with this assessment, but other relevant legislation or industry-specific guidelines should also be considered.

GENERAL

• For accident, emergency and health & safety information, refer to the Safety Data Sheet for this product.
• This product is registered with the National Poisons Information Service.
• While every effort is made to ensure that the information in this product information sheet is accurate, it is given without guarantee since the conditions of use are beyond our control.