pH Meter 0-14 with Temperature Measurements 0-80'C

pH Meter 0-14 with Temperature Measurements 0-80'C

Pen Type Water Quality ph meter 0-14 pH with temperature measurements 0-80'C

Durable and robust plastic casing complete with black plastic protective case. The pH testing kit comes complete with buffer powder sachet of pH4.0, pH6.86 & pH9.18 and 3 batteries included

• LCD pH Meter Measure
• Range: 0.0-14.0 pH
• Resolution: 0.1 pH
• Accuracy: ±0.1 pH (20¡C)

Please note: Ph Meter is Pre Calibrated by the supplier. Calibration solutions can also be purchased separately.

See our range of calibration solutions below.

• pH Calibration solution pH 7.01
• pH Calibration solution pH 4.01
• Calibration solution for pH

How to operate a pen type water quality ph meter?

1. Remove the protective cap
2. Rinse the electrode with distilled water and dry with filter paper
3. Turn the pH on , the switch is located on top of the pH pen
4. Immerse the pH meter electrode in the solution to be tested
5. Stir gently and allow the reading to stabilise
6. After use, switch off the pH meter and again using distilled water clean the electrode and replace the protective cap

How to calibrate a pen type water quality pH meter?

1. Immerse the electrode in pH 6.86 buffer powder (at 25 degrees c) and gently shake the electrode
2. Regulate the trimmer (located beside the back clip) with a screwdriver (included in box) until the buffer solution matches he digital reading
3. Immerse the electrode in buffer powder 4.01 and repeat previous steps to correctly calibrate the pH range